BOILER WATER SEQUESTERANTS AND SLUDGE CONDITIONER
S.F.C 806
407-806

PRODUCT USES:

Thermidaire S.F.C 806 is an aqueous solution of chelating agents, organic polymers, and tetrasodium salts. This product is used when sludge can effect the efficient of the boiler system
Thermidaire S.F.C 806 is a highly charged anionic polyelecectrolyte; liquid blend designed to prevent deposit formation in boiler water systems and will result in clean heat transfer surface.
Thermidaire S.F.C 806 Inhibits and distorts calcium carbonate crystal formation and effectively disperses iron oxides so they can be removed easily by normal blow-down under boiler operating conditions
Thermidaire S.F.C 806 is a sludge and foam product being a hydrophilic colloid, non-toxic substance that completely dissolves in water. Thermidaire S.F.C 806. reacts readily with metallic ions such as calcium and iron to form a large flock or colloidal precipitate of the metal. It will not attack nor dissolve the iron from the boiler shell, walls or tubes.
Thermidaire S.F.C 806 is used for the carry-over prevention in boilers or evaporators and to remove the heavy sludge

DESCRIPTION:

Physical State: Liquid
Colour: Clear to slightly turbid.

ADVANTAGES:

Non-toxic and non-hazardous product.
Very easy to handle.
Prevents foaming in boilers and evaporators.
Reduces foaming and priming.
Prevents carry-over of the boiler water.
Mobilizes sludge to facilitate the removal by blow down procedure.
Reduces operating costs.

DOSAGE:

The amount of Thermidaire S.F.C 806. required will vary with different operating conditions from 1/2 to 3/4 oz. of diluted solution (4:1 per gallon of make-up water). S.F.C. should be diluted in a ratio (1 quart of S.F.C. to 3 quarts of tap water) and injected continuously to the suction of the boiler feed pump, or directly to the boiler for each gallon of feed water required.

FEEDING:

Thermidaire S.F.C 806 may be fed via a batch or neat. To prepare a chemical batch the product should be mixed with soft water or condensate. Introducing the mixture directly to the boiler is recommended, and it can be introduced to the feedwater tank or deaerator. Feed equipment and lines should be of corrosion resistant material. The optimum treatment level for any plant will be specified by Thermidaire Corporation and will be dependent upon the water parameters.

HANDLING:

Thermidaire S.F.C 806 (non-hazardous). Avoid breathing, avoid contact with eyes and skin, should contact occur, flush immediately with fresh water. If discomfort persists, seek medical attention. Do not take internally.

SPILL PROCEDURES:

Soak up with absorbent material and scoop out. Wash area with soap and water. Flush residue to drain with copious amounts of water. Local disposal regulations must be observed. 

Read Material Data Sheets before handling this product.

PACKAGING:

Thermidaire S.F.C 806 is packaged in 5 gallons pail or 45 gallons poly drum.